The Skis - The Surfing

   Page 1 - Page 2 - Page 3

   While hangin out with my buddy last night I started checking out his ride. This jetski came good to go with a ton of great parts, but poorly built. After going thru just about the entire craft, Ryan Bevington has finally got everything coming together as it should be. Built around a high output 760cc setup with a Riva FreeRide Dry pipe and lightened flywheel, this ski is down right ballistic! As with any "race" engine, it requires a bit more than your normal maintenance but it well worth the time once you get out out on the lake. I personally estimate this ski to be around 100+ horsepower, and with the proper hookup I bet it goes 57mph to 58mph (just my guess, we'll get GPS readings soon!)

Installed:
Custom Paint 
GOKI Starter 
HydroTurf Mat Pad 
Lightened Flywheel (GroupK) 
MSD Electronic Water Injection 
Primer Kit 
Riva 760cc Sleeves/Setup
Riva Flame Arresters
Riva FreeRide Dry
Riva Intake Spacers
Solas "I"
Solas Top Loader Intake Grate
UMI Pole Spring (Black)
UMI 0* Extended Bars
Worx Extended Ride Plate 
800gph Rule Bildge w/mount + plumbing + Bucket Switch

Ryan and his SuperJet.

Get those California #'s Off there! (yea, we drove like 1000 miles each way to pick this puppy up from So. San Francisco).

Notice the slick rivet job replacing the stock plastic screws on the bumpers...

Black Bottom Action.

Nose, hmm, white gas cap, how odd, might have to swap it out with the "Springer" Yamaha WaveRunner SuperJet 1998 black assy.

Lets have a peek under that hood shall we...

GroupK Lightened Flywheel 4oz. I believe.

Goki Starter Gear Install 

Heh, Solid Gold parts, I knew there was a reason this stuff is so spendy ;)

Toast stock starter.

MSD Water Injection (EWCI)

So then it was like 4 am and it was time to chow, packed it up and headed out for some breakfast. I'll go back over there again tonight and see if things get finished up.

Page 2

Copyright © 2002 SkiSurfing.Com All Rights Reserved. Privacy Policy.